GRC構件的嵌入式部件和連接器的設計應滿足相關文件的要求；因此，在設計
濟南GRC構件的嵌入式部分時，我們需要考慮以下因素：
The design of embedded components and connectors of GRC components shall meet the requirements of relevant documents; Therefore, when designing the embedded part of Jinan GRC components, we need to consider the following factors:
1.它具有足夠的剛度和強度，可以承受GRC部件在自身重量，風載荷和地震載荷下傳遞給嵌入式部件的內力。
1. It has sufficient rigidity and strength to withstand the internal force transmitted by GRC components to embedded components under its own weight, wind load and earthquake load.
2.滿足運輸，安裝和吊裝過程中的建筑負荷要求。
2. Meet the building load requirements during transportation, installation and hoisting.
3.對于變形受到限制的部件，將產生很大的內力，并且嵌入部件應與連接構件結合在一起，以形成可移位的彈性接頭系統。
3. For parts with limited deformation, large internal forces will be generated, and the embedded parts shall be combined with the connecting members to form a displaceable elastic joint system.
4.預埋件牢固地錨固在GRC中，錨固肋與鍍鋅預埋件之間的連接不會(huì )損壞鍍鋅層。錨固肋的錨固長度滿足混凝土中錨固長度的要求，并具有足夠厚度的保護層。
4. Embedded parts shall be firmly anchored in GRC, and the connection between anchor rib and galvanized embedded parts shall not damage the galvanized layer. The anchorage length of the anchor rib shall meet the requirements of the anchorage length in the concrete and shall have a protective layer of sufficient thickness.
5.埋入部分和錨固肋應部分加固以適應應力集中。
5. The embedded part and anchor rib shall be partially reinforced to adapt to stress concentration.
6.嵌入零件的位置正確。特別是，邊緣的構件（例如嘴，窗戶，門道和拐角）必須正確定位和定向。
6. The position of embedded parts is correct. In particular, the components of the edges (such as mouth, window, doorway and corner) must be correctly positioned and oriented.
7.外部探測的嵌入式零件的外部長度和鉆孔位置設計正確，適合安裝。
7. The external length and drilling position of embedded parts for external detection are designed correctly and suitable for installation.
8.對于重量大于50kg的構件，應提供一個環來固定電纜，以使該構件除了安裝節點外還具有非剛性的懸掛連接以防止跌落。
8. For components with a weight greater than 50kg, a safety ring shall be provided to fix the safety cable, so that the component has non rigid suspension connection in addition to the installation node to prevent falling.
The above is what needs to be considered when designing the embedded part of GRC component. You can visit our website for relevant contents of this component http://www.hrstitr.cn Consultation and understanding.
